After connections are established, a tiny trim cover conceals screw access holes for a clean finish. Its tiny dimensions (12.6 x 2.1 x 7.1 inches) should make it easy to store.Īll amplifier terminals are insulated and covered, and all couplings are on one edge. The Excelon XR600-6DSP is a six-channel, bridgeable, Class-D amplifier. Kenwood Excelon P-XR600-6DSP amp features 2 and 4 ohms up to 6 channels and 4 ohms up to 3 bridged. 10-channel 32-bit 192 kHz digital processor improves signal responsiveness. The P-XR600-6DSP offers 54-step three-band parametric EQ from 44 Hz to 19.9 kHz. The amp delivers a clearer signal than combining factory-amplified signals, processing and reducing amp noise, and then re-amplifying for the speakers. The amplifier can also drive four speakers with Channels 1-4 and a subwoofer with Channels 5-6 in bridged mode. This Kenwood Excelon amplifier adds clarity and bite to your audio. Flash the iDatalink Maestro AR module with the right parameters to tune. You don't need to be an oscilloscope and spectrum analyzer expert to level and total the signals. Most automakers are supported, and more are being added. The Kenwood Excelon P-XR600-6DSP amp, paired with the accompanying iDatalink Maestro amp replacement module, replaces the original amp and provides a lot of power and tuning ability to your system while keeping all of the vehicle’s audio and communication features. Kenwood Excelon P-XR600-6DSP - Budget Pick You can connect this amp into practically any factory system, even if it has pre-filtered, time-aligned, and boosted signals to separate factory speakers and tweeters. It allows for proprietary interface solutions, controllers, and inputs. The D-6.1200's Option Port allows hi-res streaming directly into the DSP. The D-6.1200 combines power and versatility in a cast aluminum chassis, making it perfect for OEM and aftermarket designs. This impedance occurs in a bridged channel at 14.4V DC. 102 dB signal-to-noise ratio and 0.25 – 8V input signal voltage provide superb sounds without distortion.ĪudioControl's 6-channel D-6.1200 amp can handle 2 and 4 ohms of output impedance. AudioControl's 6-channel amp provides a 20–24000 Hz frequency response. The D-6.1200 amp can recreate high-frequency sounds without changing the signal. In 3-channel mode, you may power three 400-watt subwoofers for a total of 1200 watts. This wattage is plenty for even the most demanding aftermarket speakers.įour of the D-6.1200's channels can drive 2-way components, while the fifth and sixth can be bridged for 400 watts. The amp has 125 watts per channel at 4 ohms and 200 at 2 ohms. The D-6.1200 has effective outputs, line-level inputs, and speaker level inputs, as well as full control over all functions via AudioControl's DM Smart DSP app, including polarity, thirty bands of equalization, input delay, signal delay, and AudioControl proprietary functionality like MILCTM, GTOTM Signal Sense, AccuBASS®, and integrated input and output RTA's.ĪudioControl's D-6.1200 6-channel amp provides 400 peak watts and 200 RMS. The D-6.1200 combines AudioControl's award-winning amplifier engineering with Matrix DSP for unrivaled power and tuning possibilities. This amp offers serious power and extensive control for great vehicle radio sound.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |